Installing Cobra Exhaust Pipes

I was extremely lucky to find a set of almost brand new Cobra Pipes (thanks Rex!) and replaced the stock ones.
I must say that I'm extremely happy with the sound, they are not real loud but do wake you up during heavy acceleration and deceleration. Not annoying, but they do add a bit of 'personality' to the Voyager!
The only thing that I would do different is to order the exhaust header to pipe gaskets (the ones that go inside the pipes and slip over the exhaust to seal the fitting). One of mine was bonded to the old pipe and didn't come off to good, but I was able to sacrifice enough of it to work with the new pipes until the ones' I had on order showed up
Here's some photos of what they look like.

Click on the picture(s) below to see a larger version

Loosen the clamps on the exhaust header to pipe seal and the crossover pipe
then unbolt the supports next to the passenger floorboards.

The pipes are then 'worked' back and forth until they pull off the seals.
I did one at a time.

Either go to the NEXT page or go back to the Motorcycle page
or HERE for the TINLIN.NET home page.

Original page created on 10/12/04 by Jim Tinlin